Enigma small parts.

Reproduction items:

Nur Glühlampen

4 Volt Plate

Located inside the Enigma
under the Lamp panel cover.
Denotes:
'Only lamps with 12mm diameter use'
or
should read
"Use bulbs with 12 mm diameter only."

LASER ENGRAVED
black anodized aluminum.

75mm wide x 15mm high
Cost of Nur Glühlampen plate : $32.00

Buy with Paypal soon

For M4 Enigma, Kriegsmarine
Denotes:
"For operation with built-in battery pull out plug."

LASER ENGRAVED
black anodized aluminum.
42mm wide x 34mm high
Cost of 4 Volt plate : $32.00
Buy with PayPal soon

Engraved serial ID Plates
with aged 'patina'
Shown with optional 'Na 220 900' number

53 x 18.9mm
Note: To avoid making plates with irronious serial nunbers, positive inentification of the serial number and manufacturer are required in order to proceed with a serial plate.
It is necessary to keep the historical record integrity.
Photos of the machine, old ID plate with manufacturer
(jmz, gvx, aye, bac, jla) and serial number are required.

Cost of engraved ID plate : $67.00

shown here with aged 'patina':

Specify 'M' (Navy) or 'A', serial number
and manufacturer
jla, bac, aye, gvx, jmz

Photos of the original serial number aer required.
They are usually cast into the base of the machine or inscribed on the old faded ID plate.

'Chiffriermaschinen' plate

Now available in limited quantities:
Chiffriermaschinen
Heimsoeth und Rinke

'jla' is the manufacturing code for
Heimsoeth und Rinke

LASER ENGRAVED
black anodized aluminum.

Cost : $14.00
shipping included ! (if in USA)

'Zur Beachtung' plate

(200mm x 140mm)
LASER ENGRAVED
black anodized aluminum.
Cost 'Zur Beachtung' plate : $42.00
shipping included ! (if in USA)

Engraved aluminum ID plate

LASER ENGRAVED Plates
These are black anodized aluminum
cut to the exact size of the original.
Thickness is .66mm

Just specify plate size and the Enigma number when ordering.
(example M 1234).
Cost : $16.00
shipping included ! (if in USA)
Engraved aluminum ID plate

Engraved Enigma logo

Cost : $18.00
shipping included (if in USA)

The Enigma logo plate is
LASER ENGRAVED
black anodized aluminum.
Thickness is .66 mm

The logo was mastered from a close up high resolution photo of an Enigma logo.
29 x 70 mm.
Engraved Enigma logo

Engraved WOOD Enigma plate

Cost : $7.00
shipping included ! (if in USA)

The Enigma logo plate is also offered in
Alder WOOD
LASER ENGRAVED
Alder wood Can be painted or stained.
29 x 70 mm
Thickness is 3 mm

The logo was mastered from a close up high resolution photo of an Enigma logo.
Engraved WOOD Enigma plate

See the Lamp Panel films

View your total

Postal order information at bottom of page.

Postal Order Information:
Send Cash/Check/Money Order,
along with your shipping address, to: